Sentry LT200 Manuel télécharger pdf (Page 31)

MultiPoint Level Control System

E 2001 Nordson Corporation

321 351A

Issued 7/01

69–LVL–EH–IS–01

To order parts, call the Nordson Customer Service Center or your local

Nordson representative. Use the parts list, and the accompanying

illustration, to describe and locate parts correctly.

Numbers in the Item column correspond to numbers that identify parts in

illustrations following each parts list. The code NS (not shown) indicates

that a listed part is not illustrated. A dash (—) is used when the part

number applies to all parts in the illustration.

The number in the Part column is the Nordson Corporation part number.

A series of dashes in this column (- - - - - -) means the part cannot be

ordered separately.

The Description column gives the part name, as well as its dimensions

and other characteristics when appropriate. Indentions show the

relationships between assemblies, subassemblies, and parts.

Item Part Description Quantity Note

— 000 0000 Assembly 1

1 000 000

S Subassembly

2 A

2 000 000

SS Part

S If you order the assembly, items 1 and 2 will be included.

S If you order item 1, item 2 will be included.

S If you order item 2, you will receive item 2 only.

The number in the Quantity column is the quantity required per unit,

assembly, or subassembly. The code AR (As Required) is used if the

part number is a bulk item ordered in quantities or if the quantity per

assembly depends on the product version or model.

Letters in the Note column refer to notes at the end of each parts list.

Notes contain important information about usage and ordering. Special

attention should be given to notes.

8. Parts

Using the Illustrated Parts

List

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37 38

Pas de commentaire

Sentry LT200 Manuel Page 31