Sentry Sentry 2.0 Instructions d'exploitation télécharger pdf (Page 40)

40 Cone-Fire / Ramp-Hold

Sentry Cone-Fire Shorthand Programming

After you press the key(s) in the left column, the message to the right will appear. Press from . If the key does not

respond, your controller does not have Cone-Fire. (See also page 11.)

KEYS TO PRESS DISPLAY COMMENTS

Apply power to kiln Press Enter if IdLE doesn’t appear.

1 Enter the cone number.

Cone # (i.e. 05)

ENTER Enter the firing speed.

1(Fast), 2 (Med.), or 3 (Slow) The firing speed appears.

ENTER Enter Pre-heat time.

Pre-Heat time (0 if none) Pre-heat time appears.

ENTER Enter hold time.

Hold time (0 if none) Hold time appears.

ENTER Enter slow cooling rate.

Slow cooling rate (0 if none) Shows degrees per hour.

ENTER Kiln is ready to fire.

ENTER Kiln is now firing. Press 6 for

Program Review.

The Kiln is now firing to the cone you selected.

Appendix G:

1 2 ... 35 36 37 38 39 40

Pas de commentaire

Sentry Sentry 2.0 Instructions d'exploitation Page 40